801 Slip-on / exhaust list

YanerTavuz said:
This is the result, I made a simple test bracket out of an aluminum plate, the distance between the middle of the holes is about 40-42mm. Using m8 screws and locknuts.
Tomorrow I am going to change the screw on the silencer bracket to a bit longer and add a washer so it’s the custom bracket is more straight.

Didn’t film the sound, but god damn is loud at low rpm’s and then when revving it feels to be less loud or something 🤪
Click to expand...
It follows the lines of the bike perfectly.
 
Here is the second slip-on I ordered, ordered the muffler and link pipe separately. The fitment was kinda perfect with the included z bracket, except for being in the middle of the logo 😅
 

Attachments

  • IMG_0379.jpeg
    IMG_0379.jpeg
    871 KB · Views: 17
  • IMG_0380.jpeg
    IMG_0380.jpeg
    781.9 KB · Views: 17
  • IMG_0381.jpeg
    IMG_0381.jpeg
    578.8 KB · Views: 11
  • IMG_0382.jpeg
    IMG_0382.jpeg
    477.5 KB · Views: 15
Tom said:
A few pics from some more exhaust test assemblies...

251110_01.jpg
Click to expand...
Almost the right angle for the tip of that exhaust. still looks good tough
 
Still with all the exhaust tested, none of them look as good a fit as the original. The remus nxt comes close.
Thinking of maybe blackening my original and doing that sound mod.
 
You must log in or register to reply here.
Back
Top Bottom