What Did You Do To *YOUR 801* Today?

CurveRider

fast rider
Joined
Sep 24, 2026
Messages
32
Location
Smoky Mountains
Cold weather's a good time for bike mods and I wonder what other 801 owners are doing? Since I'll likely switch my Ixil exhaust back to the OEM muffler (with an "out-of-stock" Coober decat link pipe), I started prepping the factory can for flat black, high-temp paint simply because I prefer a low-key profile. 😋 I like the stock muffler's straight-through design and tone even if it's a tad heavy.
Cheers!

PrepMuffler1.jpg
 
My muffler "blackening" is done. The ceramic, high-temp, rattle-can finish required baking at 450F degrees for 1 hour to cure and my wife kindly accommodated, after which, she did an overdue cleaning of the oven. :p I'm okay with the final muffler result. `Tis what I wanted.

PrepMuffler3.jpg

PrepMuffler2.jpg

PrepMuffler4.jpg

PrepMuffler5.jpg
 
I don't know about high temp paint, but I know if you use an over to cure powder coat you are absolutely never supposed to cook food in it again regardless of how you clean it.
 
I don't know about high temp paint, but I know if you use an over to cure powder coat you are absolutely never supposed to cook food in it again regardless of how you clean it.
Thanks for the warning about powder coat. (y) Fortunately, the high-temp paint curing produced no smoke or noxious vapors. It just sat there looking dumb and hot but if either of us suffer any deleterious future maladies, we'll know your warning might be relevant. :)
 
It's hard to believe I'm the only one personalizing their 801? 😳

No, you're not the only one 😁 Many have already done it; there are quite a few posts about it in the "801-owners-club" thread.

What I’ve done to make it my own:
Several of the optional Husqvarna parts are installed, including the Dynamic pack, the heated grips, the tank bag, the comfort seat, the pillion seat cover, the radiator guard, the exhaust bracket, and the aluminum footpegs.
In addition, I installed some bar end mirrors and some axle sliders, adapted a Duke tail tidy, had the silver aluminum parts hard-anodized in black, wrapped a set of tank covers in a satin-silver finish and the original windshield in matte black.
I also added some custom made decals, converted the optional pillion seat cover into a small luggage rack and replaced the big fork reflectors with smaller, customized ones.
Furthermore, I removed the welded in db-killer from the stock muffler and replaced it with a custom-made, short, bolt-in db-killer, and swapped the original air filter for one from K&N.
Finally, I replaced the 300mm front Galfer brake discs with 320mm Brembo discs and installed Brembo sintered brake pads.


250711_06b.jpg
 
Back
Top Bottom