The infamous Oil Thread

BISavage

champion rider
Joined
Oct 8, 2020
Messages
2,497
Location
Unspoken Origins
As every good forum has to have a ridiculously long oil thread, I though I would start one here!

Which oils do you use, and what is your old change philosophy?

I have changed the oil at the first interval as outlined in the owner's manual, and at half the interval for every change there after.

The oil I've used so far is motorex topspeed 15w50 and the filter has been changed with the oil.

The metal screens get cleaned/replaced at the full interval and not the half.

Found metal shavings at the start and some chunks of RTV, pretty normal I think.

What about everyone else?
 
I use the recommended Motorex oil, can't remember the spec. Whatever the manual says. I asked my local Husqvarna specialist (CPC) and they recommended doing just that.
 
Obligatory I RUN ROTELLA IN EVERYTHING AND YOU'RE DUMB IF YOU DON'T!

But seriously, just run what's in the manual. I get that Motorex has an exclusive partnership with KTM/Husky, but they make good stuff. That being said, I'd probably change the oil at half the recommended interval instead of the full 10k.
 
But really though, like only motorex sells 15w50.
Rekluse oil? Royal purple oil? Super generic no name oil? These selections would force one to pour in a far inferior 10w40 or 20w50 multigrade, and blatantly ignor the manufacturer specifications for proper bike care!

If only there were another option...

20201010_212340.jpg
 
I'm likely to use Castrol Power1 Full Synthetic 10W50 in my bike. I have a couple bikes, and I like to use the same oil in all of them. I change the oil in my KTM 350EXC all the time (every 10 hours) so I tend to keep this stuff around. Also, I'm in San Diego... so I don't think the winter number is too critical here. ;-)
PXL_20201010_212945977.jpg
 
A 10W oil is more "winter proof" than a 15W oil though. If you live in a country where it's always hot, going to a 20W oil makes more sense than going to a 10W.
 
I also like to put in the stuff that make my engine the most quiet.

Then I dont have to turn up my Taylor Swift music so loud.
 
Last edited:
In between songs yeah, otherwise it would be way too long.

Or do you mean the engine noise? That is always noticeably quieter.
Kinda like honey coating for the valve train, except in green, and poison.
 
Update: about halfway through the life of the oil and it's color is still lookin good. It is still very noticeable that the mechanical noise of the engine is very different vs. the oil used preciously.

Also noticed particular engine seals, such as the RTV seal on the left side case cover, seem to seep a bit more vs. the previous oil. (Only noticeable when dirty and could also be related to seal age or weather conditions)
 
I was just thinking, in the past for certain vehicles which ran with synthetic oil, the oil changes were done at extended intervals (or not at all). In order to do this, the inexpensive filters were changed more frequently than a standard interval and the oil which came out with the filter was replenished.

I wonder if that would work on the HQV bikes...
 
With a constant mesh gearbox and wet clutch, I'd never do that. The gearbox constantly chews at the oil's molecules, and the clutch pollutes it.
 
The question about filter changes popped up because I have currently been changing oil & filter between 3500 to 4000km.
And at the normal interval of 7500 I clean/replace screens as well (so every second change).

I was thinking about if it would be enough to replace only the filter and fill it back up at half interval in order to make it to the oil last to the full interval.

This would save about 1L oil for each full interval of 7500.
 
I don’t know. I’d rather do it the other way around. Oil only at 3k, and oil, filter and screens at 6k.

My DR650 had a similar interval, filter every other oil change.
 
Back
Top Bottom