Fender Eliminator
- Thread starter Portable_Guru
- Start date
Again hi Yonsson,
I deleted my last post as the information about the angle of the arm was wrong.
Today I checked the measurements and dimensions again and the angle of the arm is fine!
According to information from Evotech, the license plate of the Duke 390 tail tidy should be 40 degrees.
I measured it and it was only about 36 degrees.
So I assumed that the angle of the arm wasn't quite right.
I have now checked all dimensions again and it appears that the angle of the license plate holder plate supplied differs from the information provided by Evotech.
I have now mounted the arm with the baseplate without making any changes to the arm and will just adjust the license plate holder plate so that the license plate can be mounted at an approximately 45 degree angle.
I deleted my last post as the information about the angle of the arm was wrong.
Today I checked the measurements and dimensions again and the angle of the arm is fine!
According to information from Evotech, the license plate of the Duke 390 tail tidy should be 40 degrees.
I measured it and it was only about 36 degrees.
So I assumed that the angle of the arm wasn't quite right.
I have now checked all dimensions again and it appears that the angle of the license plate holder plate supplied differs from the information provided by Evotech.
I have now mounted the arm with the baseplate without making any changes to the arm and will just adjust the license plate holder plate so that the license plate can be mounted at an approximately 45 degree angle.
Last edited:
Agree! I'm also very pleased with the result!
I don't plan to fabricate any parts to sell them; developing and fabricating parts like this is just a hobby (that I love); when I find time for it...
Here another pic:
Looking good! Don’t forget to post some pics here as well:
hqvadventure.com
801 owners club
A thread for us 801 owners, to share info and experiences. I got mine a week ago. After 500km I’m really happy with it. It’s fast (not revving over 6500rmp before the first service), the handling is great and I really like the suspension. So far I have cleaned up the tail a little, swapped to...
hqvadventure.com
I would remote the stock rear fender and install one of these carbon fiber fender eliminators thats also a plate flipper all in one. Have a look at: 007Plate.com
I've had it on 3 or 4 of my bikes now and it's awesome.
Looks nice and it's easy to install too. Just one center bolt mounts the gadget to the motorcycle, and just connect 2 wires to the battery.
PS it actually usually takes longer to remove the stock rear fender than it takes to install it this thing
I've had it on 3 or 4 of my bikes now and it's awesome.
Looks nice and it's easy to install too. Just one center bolt mounts the gadget to the motorcycle, and just connect 2 wires to the battery.
PS it actually usually takes longer to remove the stock rear fender than it takes to install it this thing
Last edited:
Now with a lightweight, black coated aluminum composite panel instead of the raw aluminum plate to support the license plate; and with some added black stainless steel nuts…
For now this little „tail tidy project“ is completed to me; and I'am quite happy with the result!
For now this little „tail tidy project“ is completed to me; and I'am quite happy with the result!
Last edited:
