CTEK battery maintainer install

Black Arrow

contributing rider
Joined
Aug 10, 2024
Messages
11
Location
Southern Alberta
In case anyone had an interest in putting a battery maintainer on their 401

A pretty simple DIY for those that don’t put a lot of km’s on their bikes. With the cold weather coming and this being my 3rd vehicle, I figured I should get this done.

1. Unlock, remove rear seat section, front seat and then the battery cover.

2. Disconnect negative (black) wire from terminal, pull safely away from terminal. Then, disconnect positive (red) terminal, pull aside. 10 mm socket for both.

3. I installed CTEK comfort connect (quick connect) wires to terminal, in reverse order to above. I.E. positive (red) first, then negative. I couldn’t find torque specs on battery terminal screw bolts, so I went with tight. If anyone knows the spec, please let me know.

That’s it. The connector sits under the rear section of the seat. So once I use the key, pop the rear seat section there it is - the quick connect takes a few seconds to connect / disconnect.
 

Attachments

  • IMG_0035.jpeg
    IMG_0035.jpeg
    715.3 KB · Views: 11
  • IMG_0034.jpeg
    IMG_0034.jpeg
    386.9 KB · Views: 11
  • IMG_0032.jpeg
    IMG_0032.jpeg
    421.9 KB · Views: 11
Looks fine.....those chargers are nice.
If u cut and splice more cable that the female connector is attached to u can trail (and nylon tie) it inside either side cover.
That way u don't need to take the seat off to use the charger and u have a 12v output source.
 
Of course everyone is free to do whatever they want with their bikes.

If you want to splice wires, have the plug outside and need a 12 volt power source - feel free.

For me, I like the plug protected under the seat, and the clean look. I am willing to spend the maybe 30 seconds popping the rear seat.

Each to his own.
 
Back
Top Bottom