Hello all, I am crap when it comes to electrical, maybe someone can help me. I want to add bar end lights (motogadget mblaze led) to my Svartpilen, when I open the hand controls there are 3 wires. Just doing a little trial and error, when I touch the black wire for the light to the grey wire and the red to either the orange or green, the light flashes. Shouldn't it only flash on one or the other when only right or left signal is selected?
Could it be because I don't have the LED relay? I do have that on order along with the led signals from Europe, but it still doesn't make sense to me to get power off both.
I'd like to try and tie into the hand control unit so I don't have to run another loom to behind the headlight.
The electrical schematics are Greek to me, it does show the grey goes to or comes from relay, then green and orange are left/right signal.
Any help appreciated, stay sexy my fellow back and white arrow riders!
Could it be because I don't have the LED relay? I do have that on order along with the led signals from Europe, but it still doesn't make sense to me to get power off both.
I'd like to try and tie into the hand control unit so I don't have to run another loom to behind the headlight.
The electrical schematics are Greek to me, it does show the grey goes to or comes from relay, then green and orange are left/right signal.
Any help appreciated, stay sexy my fellow back and white arrow riders!
