No gear indication

R

rekoeleman

new rider
Joined
Mar 20, 2025
Messages
3
Location
The Netherlands
After bleeding the clutch and replacing some parts in the master piston I don't have any gear indication no more. It's blinking gear in the display-unit and showing only a stripe. Furthermore I cannot start my engine without holding the clutch and after a short ride TC failure appears. This problems wouldn't be a cause of some bleeding and replacing. Does anybody known what causes these electronical fails?
 
Sometimes it's the battery . Even though a voltage reading seems good. Sometimes it's just a random glitch . Disconnect battery for 1/2 hour. And see if it resets. I'm assuming no switches or sensors were unplugged or damaged during this. Clutch switch, abs sensor neutral , gear , etc .
 
Ok there's no TC failure anymore. Still I got no reading of the bike indicator and only starts with clutch pullen in. I think this might be the problemen when there's no neutral reading it will not start. Any Quick fix for these?
 
rekoeleman said:
Ok there's no TC failure anymore. Still I got no reading of the bike indicator and only starts with clutch pullen in. I think this might be the problemen when there's no neutral reading it will not start. Any Quick fix for these?
Click to expand...

Not a fix, but try this.

Cycle through the gears with the bike off. Go all the way up to 6th, and then to first.
Turn the key to ACC power and find neutral. The green light should turn on even if the gear Number/letter doesn't show on the dash.
At this point, you should be able to turn the bike on with the kickstand down and no clutch. (Hold the front brake just in case)
 
Do u have an OBD2 scanner to read and clear any possible fault codes ?
 
Last edited:
Maybe you incidentally pulled/pushed on some wires while bleeding the clutch and some connectors for the gear position sensor got loose?

Did the 15min idle reset thing work?
 
You must log in or register to reply here.
Back
Top Bottom