Clutch Lever Adjustment

[bob]

2019 Svart 701
Is there any way to adjust the clutch lever? Clutch works great but I prefer the clutch to release a little closer to the handlebars. Right now when leaving a red light the clutch doesn't engage until the lever is pretty far out. I'm old and used to cable clutches .

 

[Alexandru.k_24]

I think that the only way is to replace the slave cylinder with an adjustable one. As far as I know, Rekluse is making one for the 701 Supermoto. But, since is the same as the one on Svartpilen/Vitpilen 701, should work just fine.

 

[zoop]

I had the same issue and after a master rebuild it's much better. I'd bleed your clutch first and if that doesn't work try to rebuild the master.

 

[Brewster]

There was a factory recall for the clutch slave cylinder see this link. You can check to see if your bike is affected and if it has already been replaced?

https://www.google.com/url?sa=t&source=web&rct=j&opi=89978449&url=https://www.husqvarna-motorcycles.com/language-masters/en/service/recalls/Recall_LC4%2520models_06.10.2021.pdf&ved=2ahUKEwi5g7qMlfeFAxVsW0EAHUU3ClQQFnoECBsQBg&usg=AOvVaw1zQFkS_e_fFhMF3F4D7vU0

 

[DWB]

You can replace the lever to one that has adjustable lengths.