Finally happened to me.....

[FredFrenzy]

I got the TC Failure and CAN Failure briefly when I pulled away from a stop light. The Yellow Engine light came on and stayed.
Bike seemed to be running fine....I disconnected/reconnected the battery, but the light is still on. My battery has a 4/18 date tag on so going to upgrade to a lithium.

I though this had an OBD2 diagnostic port - want to read/clear the faults. Anyone know where the port is?

thanks barry

 

[nampus]

The connector is under the seat, on the right hand side near the battery. It's a 6 pole connector.

I've had the can abs failure numerous times but it has always disappeared after a couple of seconds without any other symptoms.
Don't think I ever had a tc failure though.

 

[BISavage]

To Connect I use an adapter like this:

 

[MoeZambeek]

How’s your clutch?
Your symptoms are the same as mine, except my bike would stall alongside the TC and ABS failures and not restart immediately when trying to pull away from a light (after having been sat with clutch in at said light).

I have also had CAN HLU failure warnings with a failing battery, but generally only just after starting; once running (and therefore charging) it was fine. I guess it’s possible your battery is failing to the extent that it won’t charge though.

 

[FredFrenzy]

How’s your clutch?
Your symptoms are the same as mine, except my bike would stall alongside the TC and ABS failures and not restart immediately when trying to pull away from a light (after having been sat with clutch in at said light).

I have also had CAN HLU failure warnings with a failing battery, but generally only just after starting; once running (and therefore charging) it was fine. I guess it’s possible your battery is failing to the extent that it won’t charge though.

It did stall - sounds very much like what I experienced.. New battery on the way just to get that off the table.

 

[FredFrenzy]

To Connect I use an adapter like this:

Thanks! one on the way.

 

[Max Kool]

To Connect I use an adapter like this:

What can you do with that? Reset service to 6000 miles?

 

[BISavage]

What can you do with that? Reset service to 6000 miles?

Connect the KTM port under the seat to an obd tool...
Although I am yet to have unlocked the full power of the adapter cable (which I got from Coober by the way), it can be certain the the possibilities know no bounds.

 

[Max Kool]

I am asking because access to the ECU seems to be very limited on these bikes. Keep us posted please.