Hi I'm new to the forum and hopeing someone out there can shed a bit of light on my problem
I have a 2010 sms 630 which starts runs for a few seconds then cuts out symptoms are as follows
Ignition on fuel pump primes
Hit start button engine starts sounds fine and accelerator works fine
Runs for a few seconds then engine cuts out neutral light starts blinking 4 flashes stops 4 flashes stops
Hit start button again engine turns but won't fire
Ignition off and back on starts then cuts same as previous
Bike has had complete pump setup and college throttle body
I understand the neutral light is showing a fault but can't find anything that will read my ecu
So main 2 questions anybody had this probe (known issue)
Or did anyone ineeds England have a ibeat system set up either for sale or could read my ecu for me as I'm stumped Don all the electrical testing I can think of been repairing bikes 30 years or so but this has got me stumped any help greatly appreciated I'm in North East England
Thanks phil
I have a 2010 sms 630 which starts runs for a few seconds then cuts out symptoms are as follows
Ignition on fuel pump primes
Hit start button engine starts sounds fine and accelerator works fine
Runs for a few seconds then engine cuts out neutral light starts blinking 4 flashes stops 4 flashes stops
Hit start button again engine turns but won't fire
Ignition off and back on starts then cuts same as previous
Bike has had complete pump setup and college throttle body
I understand the neutral light is showing a fault but can't find anything that will read my ecu
So main 2 questions anybody had this probe (known issue)
Or did anyone ineeds England have a ibeat system set up either for sale or could read my ecu for me as I'm stumped Don all the electrical testing I can think of been repairing bikes 30 years or so but this has got me stumped any help greatly appreciated I'm in North East England
Thanks phil